Quit
Troubleshooting
Product is too stiff.
Cause: Out-of-date mix.
Remedy: Use fresh mix. When using rerun,
skim off the foam and mix 50% rerun with
50% fresh mix during heavy draw periods.
Cause: Insufficient mix in the freezing
cylinder.
Remedy:
Refer to “Insufficient mix in the
freezing cylinder” section of troubleshooting.
Cause: Improper priming procedures.
Remedy: Drain the freezing cylinder and re-
prime the machine.
Cause: Viscosity control is set too cold.
Remedy: Call an authorized service
technician.
The drive shaft is stuck in the gear
box coupling.
Cause: The gear box is out of alignment.
Remedy: Call an authorized service technician.
Cause: Rounded corners on hex end of drive
shaft or gear coupling.
Remedy: Replace damaged component.
Содержание Turbo Charge 8752
