Quit
Troubleshooting
Insufficient mix in the freezing
cylinder.
Cause: Suction line is not fully submerged in
the mix.
Remedy: Arrange the suction line so the
weighted end is fully submerged.
Cause: Worn or defective check bands or o-
rings in air/mix pump assembly.
Remedy: Replace regularly. Never lubricate
check bands.
Cause: Missing, defective, or no lubrication
on the mix inlet fitting o-ring.
Remedy: Replace or evenly lubricate the o-
ring on the mix inlet fitting.
Cause: The mix pump is pumping foam.
Remedy: Incorrect handling of rerun. Remove
all foam.
Cause: Pressure switch diaphragm installed
incorrectly, or missing.
Remedy: Diaphragm must be correctly installed
in the pressure switch cap or the housing.
Cause: The pump motor is not activated.
Remedy: Place the power switch in the OFF
position. Push the reset button on the pump
drive motor. Return the power switch to the ON
position. Press the AUTO key.
Содержание Turbo Charge 8752
