Tatu Marchesan GAT 800, Руководство оператора

Страница: 30 / 72

28
HOISTS - Rev. 07 - Apr/22
5. Assembly
GATG assembly
1. Couple the boom (A) to the frame (B) using an articulation axle (C), flat washer,
castle nut and cotter pin.
2. Fasten the hydraulic cylinder (D) using the junction axles (E) and cotter pins.
3. Right after, fasten the hydraulic cylinder (F) to the frame (B) using a fixation flange
(G), bolts, spring washers and nuts; use an articulation axle (H) and cotter pin to
fasten the cylinder rod (F).
4. Assemble the hubs (I) to the frame (B) and couple the tires (J) to the hubs using
nuts from the hub itself.
5. Assemble the hoses to their respective hydraulic cylinders, as shown on the
'hydraulic circuit' page.
6. Also fasten the universal joint (K) using a junction axle (L), castle nut and cotter pin.
- Always use thread sealing tape to couple the male quick coupler to the hoses.
- During assembly, avoid that the ports touch the soil.
- When finishing to assemble the hydraulic hoses, carry out a general inspection to
check the tightening of all hose ports and if they are properly installed.
IMPORTANT
A A
B B
C C
D D
E E
F F
G G
H H
I I
J J
K K
L L