TARAL 850, Инструкция по эксплуатации, Страница: 63 / 102

Run the tractor at idle speed after oil replacement
in order to enable proper lubrication of
transmission parts.
REPLACING THE OIL OF FRONT AXLE
First remove the plugs (1) shown in "Figure 42".
Then, remove the plugs (2) shown in "Figure 42"
and (1) in “Figure 43” and let the oil flow out. After
the oil is full discharged, replace the seals and
mount the plugs (2) shown in "Figure 42" and (1) in
“Figure 43” and fully tighten.
To replenish, use suitable oil described in “Table 6"
at the level specified without overflowing by
placing a funnel on the plug holes (1) shown in
“Figure 42” . After replenishing, mount the plugs
back and place the cover.
After oil replacement, wait for 15 minutes to allow
the oil to penetrate and check the oil level to make
sure.
To check the front axle oil level, remove the plugs
(3) shown in “Figure 42”. Normally the oil level
reaches just under this plug.
After any kind of oil replacement procedure and on
a daily basis, check the plugs, joints and hoses for
oil leakage; if any leakage is identified, consult you
dealer as soon as possible for remedy.
Figure 41
1
CAUTION
Figure 42
Figure 43
1
3
2
1
CAUTION
51