TARAL 850, Инструкция по эксплуатации

Страница: 61 / 102

BRAKE FLUID
The tractor has hydraulic brakes which use
hydraulic pressure to function. If the amount of
brake fluid decreases due to some reasons, it must
be topped up.
The hydraulic brake reservoir shown in “Figure 38”
has two lines; this represents the range for normal
brake fluid level.
If the fluid level decreases, open the cap (1) shown
in “Figure 38” by turning it counterclockwise and
add any oil from “Table 6” as much as necessary to
reach the proper level.
Pay maximum care while refilling the brake fluid;
avoid contact with your skin or eyes and do not
inhale. If the brake fluid accidentally contacts with
an open wound, eyes or skin, or if it is inhaled or
swallowed, wash the contact area with plenty of
water and immediately see your doctor.
The brake fluid can cause the paint of the tractor
or other contacted areas flake away due to is
chemical content. Pay attention to avoid spilling
out while using it.
Never try to replace brake fluid. This requires post
adjustment and removing the air from the system;
therefore it should only be performed by
authorized dealers.
Only use the oil types recommended in "Table 6"
or an equivalent "DOT 4" oil for brake fluid. Using a
different oil type may cause damage on seals,
which can lead to decreases in oil or air formation
in the system due to evaporation. The braking
function might be partially or completely affected
from these causes, which can lead to accidents
with injuries or even deaths.
Figure 38
CAUTION
CAUTION
CAUTION
CAUTION
1
49