TANDBERG Voyager E5784, Справочное руководство

Страница: 370 / 384

Setting of the Remux Card for Data/PSIP and DVB-Subtitles Input
Page J-8 Reference Guide: Voyager E5784 and E5788 HD DSNG Encoder
ST.RE.E10137.3
Table J.4: Example 2 - PSI on one ASI Input, Data on Other Inputs
PMT PID = 0x10 (program number 2 is being used)
Video PID = 0x11
Audio 1 PID = 0x14
Port 1 PSI data
Audio 2 PID = 0x15
The Encoder’s SI is switched off to
allow external PSI insertion.
PSIP EIT, ETT, MGT, VCT follow the ATSC standard
Port 2 ACAP data PID range from 8000 to 8100, typical use of 5 active
PIDs at a time. The PID values change regularly.
Port 3 Net data PID range 6656-6911 and bandwidth is 200 k –
500 kbit/.
In this case, the setting sequence is:
1. Configure the host service to match the requested PID values for: PCR,
Video, Audio-1 and Audio-2.
2. Set the SI Level to Off.
3. Set the value of DATA 2 Min PID to 8000 and the value of DATA 2
Max PID to 8100.
(The ACAP-data PID range is from 8000 to 8100.)
4. Set the value of DATA 3 Min PID is set to 6656 and the value of
DATA 3 Max PID is set to 6911.
(The Net-data PID range is from 6656 to 6911.)
5. The value of PSIP Min PID is set to 16 while the value of PSIP Max
PID is set to 8147. It is assumed that ETT, MGT, VCT are on the PID
number 8187.
6. Set the entry Remux input 1 in mode to PSIP.
7. Set the entry Remux input 2 in mode to DATA.
8. Set the entry Remux input 3 in mode to DATA.
9. Set the SI Level to Off (Ext.PSIP/PSI).
CAUTION…
In this example, the pid values of port-1 and port-2 are partially overlapped.
Care must take to avoid any conflict.