TANDBERG Voyager E5784, Справочное руководство

Страница: 369 / 384

Setting of the Remux Card for Data/PSIP and DVB-Subtitles Input
Reference Guide: Voyager E5784 and E5788 HD DSNG Encoder Page J-7
ST.RE.E10137.3
J.5 Examples of Complex Setups
J.5.1 Example 1 - Everything on One ASI Input
In this example, an external generator provides both PSIP, PSI tables and
other data on other elementary streams on one ASI input.
NOTE…
This was already possible on Encoder builds prior to 3.8.0. where the SI level setting
Off (Ext.PSIP/PSI) was available.
Assume the PID map shown in Table J.3.
Table J.3: Example 1 - Everything on One ASI Stream
PMT PID = 0x20 (program number 2 is being used) The Encoder’s SI is switched off to
allow external PSI insertion.
Video PID = 0x21
Audio 1 PID = 0x24
PSI data
Audio 2 PID = 0x25
PSIP EIT, ETT, MGT, VCT follow the ATSC standard.
Other data PID range from 500 to 1300, typically only 5 active
PIDs at a time but the PID values change regularly.
In this case, the setting sequence is as follows:
1. The host service is configured in order to match the requested PID
values for: PCR, Video, Audio-1 and Audio-2.
2. Assuming that the Remux card input number 1 is the only active input,
set Remux input # in mode to PSIP and the other two input modes
to Off.
3. Set the SI Level to Off.
4. Set the value of PSIP Min PID to 32 and the value of PSIP Max PID
to 8147.
(The data PID range is from 500 to 1300 and the PMT pid value and
the default EIT range is from 8144 to 8147.)
5. Set the SI Level to Off (Ext.PSIP/PSI).
J.5.2 Example 2 – PSIP and data on different inputs
This example can be considered an evolution of the previous one in
para J.5.1.
The Remux card input number 1 is used for PSI/PSIP data, number 2 and 3
are both used for other data.
NOTE…
This was not possible on Encoder builds prior to 3.8.0.
Assume the following PID map: