__________________________________________________________________________
Tandberg SLR Reference Manual
4-1
4.
Mounting Specifications
4.1. General Mounting Information
Mounting
Positions
Recommended mounting position is either horizontal with the indicator LEDs to the right, or
vertical with the LEDs up.
Mechanical
Dimensions
The Drive occupies a half-size 5.25-inch slot with standard holes for
3 mm mounting screws on both sides of the Drive chassis. In addition, four 3 mm standard
mounting holes are located at the bottom of the Drive. See Figure 4.1 for the mechanical
dimensions of the Drive.
Dimensions are in mm
General tolerances:
+/-0.5 mm
47.4
±0.5
79.2 ±0.5
Mounting Holes M3
4 on base
6 on right side of chassis
10.0 ±0.5
203.0 ±0.5
139.
7 ±
0.
5
146.
0 ±
0.
5
149.
0 ±
0.
5
(212.5 ±0.5)
8.0 ±0.5
43.0 ±0.5
41.3 ±0.5
79.2 ±0.5
79.2 ±0.5
79.2 ±0.5
Right Side
View
Left Side
View
Mounting Holes M3
4 on left side of
chassis
Figure 4.1 Drive Mounting Details (European Projection)
Mounting Screw
Requirements
•
Only M3 (metric) screws must be used for mounting the Drive
•
Maximum permitted screw depth
1)
is:
5.3 mm
•
Minimum required screw depth is:
4.0 mm
•
Screw torque, mounting screws:
0.9 Nm
•
Recommended screw length
2)
:
- For mounting bracket thickness between 0,7 and 2.0 mm,
screw length = 6.0 mm
NOTES:
1): “Screw depth” = The penetrating depth of the screw into the Drive chassis.
2): “Screw length” = Screw depth + bracket thickness.
CAUTION!
To prevent the screws from penetrating too deeply into the Drive and thereby cause damage, it is of the
utmost importance that the recommended screw length specification is followed. Damage caused by use
of inappropriate screw and bracket/mounting combinations void any warranty claims!