TANDBERG Scholar MXP, Сборка, настройка и руководство пользователя

Страница: 9 / 32

1. If needed, attach 4” WHEELS
(4) to the CART BASE using
supplied WHEELS and NUTS,
and if necessary, insert PLUGS
(4) into the open ends of the
CART BASE.
2. Position the VERTICAL
SUPPORT POSTS (2) into the
CART BASE as shown.
3. Use 3/8”–16 x 1” HEX BOLTS
& WASHERS (2) to secure the
VERTICAL POSTS to the
bottom of the cart.
NOTE: Ensure that the
WHEELS are set in the LOCK
position before proceeding.
4. Use 3/8”–16 x 1” HEX BOLTS
& WASHERS (4) to secure the
VERTICAL POSTS at the back
of the cart.
5. Mount the HORIZONTAL “U”
CHANNELS (2) to the UPRIGHT
SUPPORT POSTS using 3/8”–
16 x 2¾“ HEX BOLTS and
WASHERS (4).
6. Fasten the cart’s HANDLES (2)
to the HORIZONTAL “U”
CHANNELS using 3/8”–16 x
1” HEX BOLTS, WASHERS, and
NUTS (4).
IT IS RECOMMENDED THAT
THE NECESSARY CABLES FOR
THE SYSTEM ARE RUN
THROUGH EITHER OR BOTH
VERTICAL POSTS AT THIS
TIME.
Refer to the WIRING DIAGRAM for
necessary cables to run per
system/room requirements.
Page 9 of 32 TANDBERG SCHOLAR ASSEMBLY, SETUP AND USER GUIDE | D50564.01