TallyGenicom 9050N -, Руководство пользователя

Страница: 78 / 172

5-20 User Manual
PRECAUTIONS AND LIMITATIONS
Networking
Setting Up the Computer
• Be very careful in setting up IP addresses which are controlled as an entire system.
Consult your network administrator before performing any setup on IP addresses.
• Before performing any network setup (such as the IP address) to a host running under NIS
(Network Information Service), consult the NIS administrator.
When setting a UNIX workstation, note the following also:
• The setup procedures and commands may vary according to different versions of OS.
• To setup the printer, the user must be a superuser. Contact your network administrator to
perform the setup if you do not have the authority of a superuser.
• The print language/mode is determined by the printer model and configuration. Before
setting a UNIX workstation, check the available languages/modes.
• To specify multiple entries for the logical printer, make sure each printer entry is assigned
its own unique spool directory. If a single spool directory is used for multiple printer
entries, the printer select option may not function correctly.
PRINTING FROM WINDOWS
Take note of the following when printing from Windows:
• In the spool mode, if the print data is bigger than the remaining capacity of the hard disk
or the memory at the point of receiving, the data will not be received by the printer.
NOTE: Some client computers may re-send immediately when the print data has exceeded the receiving
capacity. When this occurs, the client appears as if it has crashed. To rectify this situation, the client
computer must be stopped from sending print data.
NOTE: In the non-spool mode, printing will commence once data starts to be received by the printer.
Therefore, if the printer has accepted a print request from a computer, it will not receive another
print request from another computer.
NOTE: For PCL and DUMP, the specification for the number of copies is invalid.
PRINTING FROM UNIX
Take note of the following when printing from UNIX:
Print
• In the spool mode, up to 32 files can be printed by one command. Files that come after the
32nd file will be ignored. An instruction with more than 32 files will be treated by the
printer as a print request of up to 32 files.
• In the spool mode, if the print data is bigger than the remaining capacity of the hard disk
or the memory at the point of receiving, the data will not be received by the printer.