TallyGenicom 8124, Руководство пользователя

Страница: 187 / 306

5.2 Description of Common Menu
187
5
Setting Con
trol Pa
nel
Allocate Memory
*3 (P.191)
The menu for changing capacity of form memory and memory of interface.
Memory allocation for the machine is as follows. The memory types that can be
allocated may be different according to the optional products installed.
{ : Supported
×
: Not supported
U
: Not supported when a Hard Disk Drive (optional) is installed.
●
After changing the memory allocation capacity, all stored data in each memory may be erased due
to re-setting of the memory.
●
Memory exceeding total capacity cannot be allocated. If the value exceeds the capacity of the
internal memory when the power is switched on, the memory allocation will be automatically
adjusted by the computer system.
●
If setting the port to [Enable] leads to insufficient memory, the port status may be set to Disabled
automatically. In this case, either set the port to [Disable] when it is not used or change the memory
allocation capacity. However, the parallel port and the USB port are not automatically set to disabled.
●
Except for print page buffer, you can allocate memory of the other memory types either through the
touch panel display or in Embedded Web Server.
●
This is the area for drawing the actual print image. The area to be allocated to print page buffer
will be the remaining area after all other memory types have been allocated. As such, the capacity
of the print page buffer cannot be changed directly. The actual capacity allocated for the print page
buffer can be checked under Memory on the [System Settings List]. And you can check it also using
Embedded Web Server.
To print high-resolution documents, configure your settings to increase the capacity of the print
page buffer.
PS
Specify the memory capacity for the Post Script.
Allocate the memory capacity in the range of 8.00 to 96.00 MB, incremented by 0.25 MB. Default is
[16.00M]. The maximum value which can be set varies depending on the available memory.
HPGL Auto Layout
Specify the memory capacity for auto layout in the HP-GL and HP-GL.
Allocate the memory capacity in the range of 64 to 5,120 MB, incremented by 32 KB. Default is
[64K]. The maximum value that can be set varies depending on the available memory.
When the Hard Disk Drive (optional) is installed, memory for the auto layout uses the Hard Disk
Drive. The capacity of memory cannot be changed. On the LCD, [Hard Disk] is indicated.
Memory type Standard
PS ×
HPGL auto layout ×
Buffer size
{
Print page buffer
{