MPEG-4 Hi-Resolution Digital Video Recorder
46
Appendix
A. Operation of DVR with speed dome
Speed dome that works with the DVR
The following speed dome camera can be set up with DVR :
Model 3021031 with 17x optical zoom
Model 3021032 with 22x optical zoom
Model 3021033 with 25x optical zoom
Configure the DVR with speed dome step by step :
Connect the speed dome with DVR via RS-485 by using twisted pair cable.
Refer to user’s manual of speed dome and DVR for detailed connection respectively.
(Recommended cable : 2547 VW-ISC UL 24AWGx2C)
User can configure the DVR through the local OSD menu (On Screen Display), or configure it through the Client
Software as shown below.
Through Client Software (refer to figure A2-1 below)
1.
Click DVR menu, select General folder
2.
On the control zone :
*Select the channel with video input of speed dome
*Select Protocol to be 302103x (represent all above models of Talitor’s speed dome)
*Input Address from 1 to 64, corresponding to the ID setting of the speed dome (since the speed dome
can be serially connected up to maximum 64 units)
*Baud rate has to be 9600
3.
Click Save to finally save all above settings
The speed dome should now be controlled by the DVR, you can try it by using the Pan-tilt control panel at the
right-hand side of the Client Software GUI.
Through local OSD menu
1.
Press Enter key on DVR front panel, and input password to enter DVR menu
2.
Press SYSTEM SETTING
?
PANTILT CONTROL
*Select the channel with video input of speed dome
*Select Protocol to be 302103x (represent all above models of Talitor’s speed dome)
*Select Baud rate to be 9600
*Input Address from 1 to 64, corresponding to the ID setting of the speed dome (since the speed dome
can be serially connected up to maximum 64 units)
