Takeuchi TB175W, Руководство оператора

Страница: 89 / 221

87
OPERATION
Operating Procedures
Cautions on Traveling on Slopes
WARNING
�
Never exceed the machine’s stability
capabilities (maximum gradeability
– 35°, lateral tipping angle – 15°). Also
note that when actual working area
conditions are poor the machine’s
stability capabilities may be lower.
�
When traveling on slopes or grades,
lower the bucket to a height of 20 to
30 cm (8 to 12 in.) off the ground. In
emergencies, lower the bucket to the
ground and stop the machine.
�
When traveling on slopes or grades,
move slowly in site travel gear.
�
Do not travel at speeds of over 20
km/h (12.4 mph) on long down slopes.
Release the travel pedal from time to
time to protect the travel motor and
ensure travel stability.
�
Do not travel down slopes in reverse.
�
Do not change directions or cross
slopes sideways. First return to a flat
surface then redirect the machine.
�
On grass, dead leaves, wet metal or
frozen surfaces, the machine may slide
sideways even on very gentle slopes.
Make sure the machine never faces
sideways with respect to the slope.
Travel Posture on a job site
Traveling up slopes
When traveling up slopes at an angle of 15°
or greater, travel in the posture shown in the
diagram above.
Traveling down slopes
When traveling down slopes at an angle of
15° or greater, change into the site travel gear
and lower the engine speed and travel in the
posture shown in the diagram above.
W2A011
90
°
~110
°
Climbing
20~30cm
(8 to 12 in)
W2A010
90
°
~110
°
Descending
20~30cm (8 to 12 in)
W2A009