
TN-906-AN
Page 15 of 20
© Tait Electronics Limited 21 December 2005
3.
Verify that the following is displayed.
PORT PARAMETERS #01:
1. Port Name: (undefined)
2. Password: (undefined)
3. Baud Rate: 57.6K
4. Bits/Parity: 8-None
5. Stop Bits: 1
6. Handshake Mode: None
7. Port Mode: Any-to-Any
74. DTR Output: Pulse
8. Supervisor Mode: Permit
9. Logoff Character: L
10. Sequence Disconnect: Three Characters
11. Timeout Disconnect: 1 Min
12. Response Type: Terse
13. Command Echo: Off
14. Accept Break: Yes
If everything is correct, proceed to step 4, or re-enter the incorrect
parameter as required.
4.
WTI APS-8 and APS-16 Units Only
This step is required because of a bug in the firmware of the APS-8
and APS-16 units. The Copy Port Parameters command does not
work for the timeout setting.
Type the following commands:
Repeat this procedure for all ports.
5.
If you do not want to configure a port as a modem port (refer to
“Configuration for a Modem Port (if a modem is used)”
below), exit
Command mode by typing:
“Configuration for a Modem Port (if a
.
/Pn [Enter]
sets RS-232 parameters
where n is the port number
11 [Enter] 6 [Enter]
enables the timeout to 1 minute
[Esc]
/X [Enter]
exits command mode