75
programming the remote control
operating manual
---
---
---
---
---
programming
macro features
Repeat steps 4 through 6 to program further keys.
7. Once you have finished teaching the AV32R Remote all the
desired commands from the original remote, you must store
them by simultaneously pressing the appropriate
REMOTE
SELECTION
key and the
ok
key for about four seconds.
Once you have stored the ‘learnt’ functions, test the keys you
have taught to make sure that they are programmed correctly.
If the AV32R Remote has problems learning from the original
remote
(1)
,you should:
• check that the original remote has fresh batteries
• avoid fluorescent lights and strong sunlight, which may
interfere with the learning process
• increase or decrease the distance between the two remote
controls (within a range of 2 to 15cm / 1 to 6in)
The keys
m1
to
m4
and
standby
can act as macro keys. These
can be programmed to store up to 10 commands to send
together with one key press. Any key press function (except
mute
,
CH +
and
CH –
) can be programmed into the macro keys. There
are 2 groups of macros, one used if the
av
,
cd
,
dvd
or
amp
remote selection keys have been pressed, the other for the
sat
,
tv
,
vcr
or
ld
keys; i.e. there are a total of 10 macros available.
1. Some remote controls operate at non-standard infra-red, UHF or ultrasonic
frequencies, and cannot be learnt; this is sometimes also caused by unusual or
complex functions which are not universally recognized. If you continue to
experience problems programming the AV32R Remote, please consult your retailer
for advice
m1
m2
m3
m4
light
cd
vcr
tv
ld
sat
dvd
tuner
md
aux
dab
---
---
GRR00892.01-AV32R OPER 3.7x 6/14/02 9:35 AM Page 75
