The ambient temperature range for tool and battery use and storage is 0
℃
-45
℃
.
The recommended ambient temperature range for the charging system during charging is 0
℃
-40
℃
.
FAQ/Troubleshooting
Working hints for your multi-purpose saw
General
1)
Always use a blade suited to the material and material thickness to be cut.
2)
Always ensure the work–piece is firmly held or clamped to prevent movement.
3)
Any movement of the material may affect the quality of the cut. The blade cuts on the upward stroke and may chip
the uppermost surface.
Troubleshooting
Symptom
Possible Causes
Solution
The multi-purposed saw
suddenly
stops
during
operation.
Overload and battery temperature too
high
Relieve the load on the machine
immediately and allow cooling for
approx. 30 seconds by running the
machine on no-load.
Low battery capacity
Charge the battery pack.
Significantly reduced
cutting efficiency.
Worn blade
Replace a new blade.
PLUG REPLACEMENT
（
ONLY FOR REWIRABLE PLUG OF UK &
IRELAND
）
If you need to replace the fitted plug then follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in accordance with the following code:
BLUE =NEUTRAL
Brown = Live
As the colors of the wires in the mains lead of this appliance may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows. The wire which is colored blue must be connected to the terminal which is
marked with N. The wire which is colored brown must be connected to the terminal which is marked with L.
Warning!
Never connect live or neutral wires to the earth terminal of the plug. Only fit an approved BS1363/A plug and the correct
rated current fuse which is used in the plug.
Note:
If a moulded plug is fitted and has to be removed take great care in disposing of the plug and severed cable, it must
be destroyed to prevent engaging into a socket.
