standard test method and may be used for comparing one tool with another.
The declared vibration total value and the declared noise emission value may also be used in a preliminary assessment
of exposure.
WARNING
: The vibration and noise emissions during actual use of the power tool can differ from the declared value
depending on the ways in which the tool is used especially what kind of workpiece is processed dependant on the
following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration and noise accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING
: To be accurate, an estimation of exposure level in the actual conditions of use should also take account of all
parts of the operating cycle such as the times when the tool is switched off and when it is running idle but not actually
doing the job. This may significantly reduce the exposure level over the total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration and noise accessories.
Plan your work schedule to spread any high vibration tool use across a number of days.
Assembly
1. Working mode adjustment
This multi-purposed saw functions as a combination jigsaw and reciprocating saw. You can use the pivot release lever to
change the configuration.
1) Lift up the pivot release lever fully until it cannot be lifted further. (See Fig. A1)
2) Rotate the front portion of the saw into any of the 6 positions (0°, 18°, 36°, 54°, 72° and 90°) (See Fig. A2). Restore
the pivot release lever. Be sure to lock the pivot release lever in place.
In Position I (0°), this multi-purposed saw can be used as a reciprocating saw.
In Position VI (90°), this multi-purposed saw can be used as a jigsaw.
