TACKLIFE TLSS01A, Руководство пользователя

Страница: 13 / 35


Adopt your way of working to the equipment.

Do not overload the equipment.

Have the equipment checked if necessary.

Switch off the equipment when not in use.
Suitable saw blades
All industry-standard saw blades with a minimum length of 127 mm with and without a pin may be
used.
7. Before starting the machine
7.1 Unpacking

Open the packaging and remove the device carefully.

Remove the packaging material as well as the packaging and transport bracing (if available).

Check that the delivery is complete.

Check the device and accessory parts for transport damage.

If possible, store the packaging until the warranty period has expired.
ATTENTION
The device and packaging materials are not toys! Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swallowing and suffocation.
7.2 General notes

All covers and safety devices have to be properly fitted be- fore the equipment is switched on.

It must be possible for the blade to run freely.

When working with wood that has been processed before, watch out for foreign bodies such as nails or screws,
etc.

Before you actuate the On/Off switch, make sure that the saw blade is correctly fitted and that the equipment’s
moving parts run smoothly.

Check that the voltage on the rating plate is the same as your supply voltage before you connect the equipment
to the power supply.

Only ever connect the equipment to a properly installed shock-proof socket which is protected by a 10A fuse as a
minimum.
WARNING
Danger of injury! Disconnect the mains plug on the scroll saw before all assembly work.
1. The length of the screws to be used varies, depending on the thickness of the table top.
2. Mark the drill holes. Use the fretsaw as a template for this purpose.
3. Drill 4 holes with a diameter of 8 mm into the work table and the rubber base.
4. Screw the scroll saw onto the workbench with the hex- agonal bolt (G) through the assembly points (fig. 3 pos20)
in the following sequence (fig. 5):
A Fretsaw
B Rubber base
C Work table
D Flat gasket
E Washer
F Hex nut
5. Tighten the hexagonal nut (F) first