T-Drill PLUS 115 CU, Инструкция по эксплуатации

Страница: 25 / 65

PORTABLE
COLLARING SYSTEM
25
PLUS 115
9.6. STALLING
If the PLUS 115 is overloaded, the adapter will break and the collaring head will stall. If
this occurs, do the following:
1. Disconnect the cord from the power source and remove the T-65 from the PLUS 115
unit.
2. Loosen the 4 screws of the knurled handle of the lead screw with 4 mm hex wrench
and remove the handle.
3. Remove the plug from the end of the lead screw and put the 14 mm hex wrench
through the hole of the lead screw and into the screw at the end of the collaring head.
4. Turn the hex wrench counter-clockwise four rounds and then tap the wrench with
a hammer in order to release the collaring head. Use a handle of the dimpler for the
turning of the hex wrench.
5. To remove the collaring head, tum the adapter by hand counterclockwise several
rounds and lift the lead screw and then the collaring head from the PLUS 115 unit.
NOTE!
¨
Before the next collar, lock the drive pin with the releasing screw and
replace the broken adapter.