Synrad Firestar V Series, Руководство оператора

Страница: 18 / 109

getting started
18
SYNRAD OEM v40 Operator’s Manual Version 4
Mounting
2 Place Firestar on the mounting surface so that slots “A” and hole “B” on the base plate line up with
the tapped holes in the mounting surface.
3 Insert 1/4–20 × 5/8" UNC capscrews through Firestar’s base plate into the threaded holes of the
mounting surface. Turn the screws by hand until the threads engage.
4 Tighten all three capscrews to a torque of 6 ft lb
f
(8 N m) maximum.
Fastening from below
To fasten Firestar to a mounting surface from below, perform the following steps:
1 Refer to the appropriate outline and mounting drawing for dimensions and then drill three 0.261"
(6.6 mm) diameter holes into your mounting surface. Hole locations should correspond to the
threaded holes labeled “C” shown in Figure 1-3.
Figure 1-3 Fastening from below
2 Place Firestar on the mounting surface so that the threaded holes on the base plate (labeled “C” in
Figure 1-3) line up with the holes drilled through the mounting surface.
3 Insert 1/4–20 × 5/8" UNC capscrews through the mounting surface into the threaded holes of Fire-
star’s base plate. Turn the screws by hand until the threads engage.
4 Tighten all three capscrews to a torque of 6 ft lb
f
(8 N m) maximum.
Top View
(v40 Fan-Cooled Model)
CA
UTION
CONDENSA
TION AND
WA
TER D
AMA
GE CAN
OCCUR IF COOLING
WA
TER
IS BELO
W DEW POINT
.
SEE OPERA
TION MANU
AL.
INVISIBLE LASER RADIATION
AVOID EYE OR SKIN EXPOSURE TO DIRECT OR SCATTERED RADIATION
CLASS 4 LASER PRODUCT
EN-60825-1, 2007
150 WATTS MAX
10510-10650 nm
C
C
C
MODEL
#:
FSV40KFD
SERIAL
#: FS40204082943
TESTED
AT
: 30V MFG: July 22, 200
8
Complies with IEC 60825-1 (2007) and 21 CFR 1040.10 excep
t
for deviations pursuant to Laser Notice No. 50 dated June 24, 2007
.
SYNRAD, Inc. 4600 Campus Place, Mukilteo
WA
98275 425.349.3500