Symbol FMT 3000, Справочник по аппаратуре, Страница: 54 / 124

3-5
FMT 3000 Hardware Reference Guide - Option Installation and Operation
The bracket also supports a bar code slot or magnetic stripe reader mounting bracket to the
right-hand side of the unit as described in
Bar Code Slot Reader and Magnetic Stripe Reader
Mounting Brackets on page 3-8.
A cutout in the base of the unit allows cable access through the rear. A plate covers the cutout
when not in use.
The gaskets prevent water from entering the unit. Ensure that water does not enter the rear
of the unit or wick down the cables and enter the unit.
Tilt Wall Mounting Enclosure
This option mounts the unit to a wall with roughly a 26˚ angle from the vertical axis (refer
to
Figure 3-3 on page 3-6). When attached on a vertical surface, the unit may be mounted
mid-chest to waist level.
The Tilt Wall Mounting Enclosure mounts to a wall with 4 to 6 bolts, screws or toggle bolts
(not supplied) depending on the mounting surface. The unit, with the 3 bracket mounting
screws (K) installed on its back (see
Figure 3-1 on page 3-3), slides into the key-hole shaped
slots on the enclosure. The case must then be opened in order to install the 4th locking screw
(K) to firmly secure the unit (as shown in
Figure 3-2 on page 3-4).