Symantec 4400 Series, Руководство по установке

Страница: 24 / 100

20 Appliance setup and initial system configuration
Front panel layout
Front panel controls
The front panel controls are the same on all models. Use these instructions to
enter all required setup information into the Clientless VPN Gateway appliance.
See
“Performing the initial appliance network setup” on page 24.
The front panel controls perform dual functions. These functions depend upon
whether the Clientless VPN Gateway appliance is in initial setup mode or if you
are using the system menu. Refer to the descriptions below. The front panel
controls consist of four navigation buttons, a select (s) button, and an enter (e)
button.
Figure 3-2 shows the front panel controls.
3 Status indicators:
The outside network activity indicator blinks when there is traffic on the outside
network interface (int1) of the model 4420. This feature is disabled on the model
4460.
The inside network activity indicator blinks when there is traffic on the inside
network interface (int1) of the model 4420. This feature is disabled on the model
4460.
The power indicator glows steadily to indicate the power is on.
The disk activity indicator blinks when there is activity on the hard disk drive.
The temperature indicator blinks to indicate temperature status. It blinks slowly
for temperature warnings and quickly for temperature failures. If the appliance
is in danger of overheating, a log message is sent to the appliance log file.
Table 3-1 Front panel descriptions (Continued)
Location Feature Description