Programming the controller
Page 28/55
SYCLOPE TERE’O Touch XL
®
Installation, starting, and programming instructions
a)
The upper panel
Programmable Flow-Switch input Active
Programmable Flow-Switch input Inactive
Non-programmed Flow-Switch input
No temperature sensor
No USB key connected
Temperature display
USB key connected
Relay not programmed
No modem installed
Relay programmed but inactive
GSM modem installed
Relay programmed and active
WIFI modem installed
Ethernet modem installed
On / Off control button
System in operation
System stopped
Pressing on this area of the screen stop or start your controller
b)
Display of a measurement channel
Time
Type of measure
Programmed setpoint
Fuse number & state
Dosing relay number
Fuse OK
Fuse KO
Alarm thresholds
High alarm threshold
Low alarm threshold
Alarms notifications
Active polarization
Maintenance or calibration of
sensor required
Tank empty
Maximum daily dosing time
exceeded
Measured value & unit
Value above the scale
Value below the scale
Value not displayable
(Technical alarm)
Display of active alarm
- Technical
- High
- Low
Dosing status
Dosage stopped
Dosage in pause
Daily overdose level