Specifications
0705
TTPM3 Printer/Encoder–Technical Manual
73
9.2.4 Ticket dimensions and perforation
NOTE! —
ISO No. 7810 says that “all points on the edges of the card in the finished
state, except for the rounded corners, shall fall between two concentric,
similarly aligned rectangles which are dimensioned as follows:
- Outer rectangle: width 85.72 mm, height 54.03 mm
- Inner rectangle: width 85.47 mm, height 53.92 mm”
Remember
these measurements when ordering tickets to be sure that they work in any
ISO 7810 compliant equipment.
Stock format
Fanfold
1
gapped or non-gapped consecutive form tickets.
Sheet-cut (single) tickets for manual or dispenser loading.
Perforation cut direction Perforation and cutting of ticket material must be done from the
thermally sensitive side of the paper.
TTPM3 accepted sizes:
- Ticket width
54 mm ±0.2 mm
2
- Ticket length
85.6 ± 0.25 mm, or 110 -150 mm
- Corner radius
3.18 mm ± 0.30 mm (0.125" ± 0,012") (preferably without minus
tolerance). Care should be taken to avoid misalignment
between the rounded corners and the straight edges of the
card. The corner radius is for optical detection of top-of form.
Card edges
Edge burrs normal to the card face shall not exceed 0.08 mm
(0.003”) above the card surface.
1
On request, versions for roll paper can be built. Requires testing with customer paper.
2
When the width of the ticket exceeds 54.10 mm, machine reading problems may occur.
