Default parameter settings
0705
TTPM3 Printer/Encoder–Technical Manual
63
3 Default
0 Min
16
10 Max
Encoding attemps, No. of tickets
Attempts
are the number of tickets the TTPM3 should attempt to encode when verification
fails. If set to 1, one ticket is encoded and if verification fails the stripe is erased, VOID
printer on the ticket and an error code sent to the system.
!H P 16 2
Two tickets will be used before giving up.
NOTE!
— See also
!F M
50 Default
1 Min
17
250 Max
Beak feed length
Determines how far the ticket should be fed out after the last pixel line is
printed.
22 Default
1 Min
18
50 Max
Cut position (Short tickets)
Determines how far the ticket should be fed from when the sensor before the
cutter sees the trailing edge, and the ticket is being cut. One step is 0.4 mm.
1 Default
0 Min
19
1 Max
Bit order for !B 1
1 means normal bit order, and 0 means reversed bit order for binary encoding
of track 1 using the
!B 1
command.
Normal means that a hex nibble 01h is encoded as 0001 (seen from the edge
of the ticket that enters first when feeding in a ticket from the rear entries).
Reversed means that the same nibble is encoded as 1000.
!H P 19 0
Reverses the bit order on track 1.
1 Default
0 Min
20
1 Max
Bit order for !B 2
1 means normal bit order, and 0 means reversed bit order for binary encoding
of track 2 using the
!B 2
command.
1 Default
0 Min
21
1 Max
Bit order for !B 3
1 means normal bit order, and 0 means reversed bit order for binary encoding
of track 3 using the
!B 3
command.
0 Default
32 Min
31
255 Max
Character sent after print
An ASCII character can be returned to the host after a completed ticket
generation.
!H P 31 3
The character 03h (ETX) will be sent by TTPM when the last
pixel line of the ticket has been printed.
