26
sWaP Signature
&
Active
user guide
www.s-w-a-p.co.uk
Contents
Important safety information (continued)
Batteries
To ensure optimal battery performance, charge a new
battery fully before using it with your sWaP watch.
When you charge the battery it will feel warm. This is
usual and the battery contains temperature protection
circuitry. However, we still strongly recommend that
you remove your sWaP watch when charging the
battery.
Batteries can cause property damage and/or bodily
injury such as burns if a conductive material such as
jewellery, keys, or beaded chains touches exposed
terminals. The conductive material may complete
an electrical circuit (short circuit) and become quite
hot. Exercise care in handling any charged battery,
particularly when placing it inside a pocket, purse or
other container with metal objects. Use only original
sWaP approved batteries and chargers.
Never dispose of your sWaP watch or battery in a fire.
Do not dispose of your sWaP watch or battery in the
household waste stream.
Recycle your sWaP watch and battery either through
a mobile phone recycling scheme or at a local waste
recycling centre. Contact your local authorities for more
information.
Vehicles
Do not use your sWaP watch when you are driving. It is
illegal in many countries to make or receive calls while
driving.
RF signals may affect improperly or inadequately
shielded electronic systems in motor vehicles. Check
with the manufacturer or its representative regarding
your vehicle. You should also consult the manufacturer
of any equipment that has been added to your vehicle.
Specific Absorption Rate (SAR)
Your sWaP watch is a radio transceiver and meets R&TTE
requirements for exposure to radio waves. It is designed
and manufactured not to exceed limits for exposure
to radio frequency (RF) energy. These limits are part of
comprehensive guidelines and establish permitted levels of
RF energy for the general population. The guidelines are
based on standards that were developed by independent
scientific organisations through periodic and thorough
evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of
all persons, regardless of age or health.
The exposure standard for wireless phone devices
employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit recommended
by the International Commission on Non-Ionizing
Radiation Protection (ICNIRP), is 2W/kg averaged
over ten (10) grams of tissue. Although the SAR is
determined at the highest certified power level, the
actual SAR level of your sWaP watch while operating
can be well below the maximum value. This is because
your sWaP watch is designed to operate at multiple
power levels so as to use only the power required to
reach the network. In general, the closer you are to a
network transmitter, the lower the power output.
Before any mobile phone is available for sale to
the public, it is tested to confirm compliance with
the guidelines (e.g., at the ear) that conform to a
uniform testing methodology determined by an expert
standards body.
The maximum results for your sWaP watch when tested
using the EGSM 900 and EGSM 1800 frequencies were
as follows (all values are stated as Watts per Kg of head
or body tissue averaged over 10 grams of tissue):
SAR values
• Please visit the sWaP website at:
www.s-w-a-p.co.uk for accurate, up to date SAR values
for your sWaP watch.
While there may be differences between the SAR levels
of various phones and at various positions, they all met
the R&TTE requirements for safe exposure. Please note
that improvements to your sWaP watch model could
cause differences in the SAR value for later products;
in all cases, products are designed to be within the
guidelines.