Suzuki NEXA BALENO, Инструкция по эксплуатации и сервисная книжка

Страница: 364 / 422

9-29
INSPECTION AND MAINTENANCE
55TH0-74E
*1: Since the lights are non-disassemble
type, you cannot replace a bulb.
Replace the target assembly if any
bulb is defective.
NOTE:
The inner surface of lens such as the
headlights or the rear combination lights
may be clouded or dew condensation may
occur by driving on a rainy day or washing
the vehicle. This is a temporary phenome-
non caused by temperature difference
between the inside and the outside of the
lights. (This is the same phenomenon as
the windows are clouded on a rainy day.)
Also, it sometimes seems that water gets
into the lights because of waterdrop on the
edge of the lens. This is a temporary phe-
nomenon caused by water adherence to
the outside of the lights.
The above-mentioned phenomena are not
vehicle malfunction.
However, if water is piled up in the lights or
large waterdrop adheres to the inner sur-
face of lens, have your vehicle inspected
by a Maruti Suzuki authorised workshop.
Non-disassembled Type Lights
Since the lights shown below are non-dis-
assemble type, you cannot replace a bulb.
Replace the target assembly if any bulb is
defective.
If you need to replace the assembly, ask
your Maruti Suzuki authorised workshop.
• Headlight (LED type) (if equipped)
• Front fog light (if equipped)
• Position light and Daytime running light
(LED type) (if equipped)
• Tail/brake light (LED type)
• Side turn signal light/hazard warning
light on outside rearview mirrors (if
equipped)
• High mount stop light
CAUTION
• Light bulbs can be hot enough to
burn your finger right after turning
off lights. This is true especially for
halogen headlight bulbs. Replace
the bulbs after they become cool
enough.
• The headlight bulbs are filled with
pressurized halogen gas. They can
burst and injure you if they are hit
or dropped. Handle them carefully.
• To avoid injury by sharp-edged
parts of the body, wear gloves and
a long-sleeved shirt when replacing
light bulbs.
NOTICE
• The oils from your skin may cause
a halogen bulb to overheat and
burst when the lights are on. Grasp
a new bulb with a clean cloth.
• Frequent bulb replacement indi-
cates the need for an inspection of
the electrical system. This should
be carried out by a Maruti Suzuki
authorised workshop.
• During bulb replacement always
use same bulb number as used in
vehicle which is imprinted on the
said bulb/unit and/or mentioned in
this section.