Suzuki LT-A450X, Руководство пользователя

Страница: 27 / 528

PERIODIC MAINTENANCE 2-9
ENGINE OIL AND OIL FILTER
The oil should be changed while the engine is warm. Oil filter
replacement at the above intervals should be done together with
the engine oil change.
ENGINE OIL REPLACEMENT
• Remove the left upper mud guard. (
$
8-9)
• Place an oil pan below the drain plug
1
, and then drain out
the engine oil by removing the engine oil drain plug
1
and
engine oil filler cap
2
.
• Tighten the drain plug, with the new washer, to the specified
torque, and then pour the new oil through the oil filler hole.
When performing an oil change (without oil filter replace-
ment), the engine will hold about 2.5 L (2.6 US qt, 2.2 lmp qt)
of oil. Use an engine oil that meets the API service classifica-
tions SF or SG and that has a viscosity rating of SAE 10W/40.
" Engine oil drain plug: 20.5 N·m (2.05 kgf-m, 15.0 lb-ft)
• Make sure that the engine is cooled.
• Place the vehicle on level ground and hold it vertically.
• Install the oil filler cap
2
.
• Start the engine and allow it to run for three minutes at idling
speed.
• Turn off the engine and wait about three minutes, and then
check the oil level on the dipstick
3
. The oil level should be
between the “L” (low)
A
and “F” (full)
B
level lines. If the oil
level is lower than the “L”
A
level line, add oil to the “F”
B
level line.
NOTE:
Engine oil expands and oil level increase when the engine oil is
hot.
Replace i nitially at 2 00 km ( 100 miles, 1 month) a nd
every 2 000 km (1 200 miles, 6 months) thereafter.