Rev. 2.4
- 36 -
© 2014 Suzo-Happ Group
Bill-to-
Bill™ 300XE
5.5.
Dispenser (BBD-0X10)
As before, ensure no physical damage is observed on the dispenser and report any excessive
damage if found to a certified technician for further analysis. Special care should be taken when
examining the cam lock mechanism on the dispenser. In many cases it may be bent or misshapen
due to the mishandling of the unit which will compromise its security. Ensure that it is replaced as
soon as any damage has been detected.
The dispenser is first cleaned by following the same steps as in Level 1 maintenance.
Next, while the dispenser is outside the chassis and the cover is opened, three belts can be seen
connected to the cover. Each belt passes through two geared pulleys and behind a drum. There must
be constant tension maintained in the three belts to ensure proper banknote dispensing. The tension
can be verified by pressing down on the section of the belt between the two white pulleys and
ensuring that resistance is felt.
The same should be done to the three belts running inside the dispenser. They run through a set of
three pulleys, one pulley per belt, and are located towards the back of the dispenser.
Use of gloves is recommended when performing above steps in order to prevent oily
residue being left on the belts
