Rev. 2.4
- 11 -
© 2014 Suzo-Happ Group
Bill-to-
Bill™ 300XE
4.1.1.
Upper Compartment
The upper compartment consists of a set of 3 o-ring rollers (bottom), bill aligning mechanism
(bottom), 3 plastic rollers (top) and 4 sets of sensors (2 on the bottom and 2 on top).
First, clean all the sensors (light guides) using a cotton-swab. Using the can of compressed air, spray
all rollers, aligning mechanism and other areas where dust has noticeably accumulated. Ensure the
can is pointing outwards when sprayed to prevent dust from entering deeper into the bill validator.
The rest of the surfaces should be wiped using the microfiber cloth and LCD cleaner.
Do not spray LCD cleaner directly on the unit. Spray on the micro-fiber cloth only.
Do not over saturate the micro-fiber cloth with LCD cleaner, apply sparingly.
Bottom section of Upper compartment:
Top section of Upper compartment:
Extra care should be taken as to not dislodge the sensors out of their place by applying
excessive force!
4.1.2.
Lower Compartment
The lower compartment consists of a set of 6 o-ring rollers (bottom), 6 plastic rollers (top) and 2
Sense-A-
Click™ modules (one on the top and the second is on the bottom). The Sense-A-Click
sensors and other hard to reach sensors should be cleaned using a cotton swab. All rollers and
sensors then have to be cleaned using a can of compressed air following by cleaning the rest of the
surface using a microfiber cloth and LCD cleaner.
Bottom section of Lower compartment:
Top section of Lower compartment: