Sutter Instrument Lambda 10-3, Руководство по эксплуатации

Страница: 40 / 132

LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
28
Figure 2-8. Filter ports (plug is removed from the loading port).
After identifying and positioning the filter cup to be loaded, it is advisable to turn off the
controller before removing the retaining ring from the filter cup. Follow the procedures
described above for installation of filters into filter holders.
CAUTION: An extra word of caution about excessive force is warranted at this point. DO CAUTION: An extra word of caution about excessive force is warranted at this point. DO CAUTION: An extra word of caution about excessive force is warranted at this point. DO CAUTION: An extra word of caution about excessive force is warranted at this point. DO
NOT APPLY EXCESSIVE FORCE! Not only do you run the ris
NOT APPLY EXCESSIVE FORCE! Not only do you run the ris NOT APPLY EXCESSIVE FORCE! Not only do you run the ris NOT APPLY EXCESSIVE FORCE! Not only do you run the risk of damaging the filter k of damaging the filter k of damaging the filter k of damaging the filter
but also the filter wheel itself can be permanently distorted by pushing too hard against but also the filter wheel itself can be permanently distorted by pushing too hard against but also the filter wheel itself can be permanently distorted by pushing too hard against but also the filter wheel itself can be permanently distorted by pushing too hard against
the retaining ring with the driver or wrench. If you experience problems securing the
the retaining ring with the driver or wrench. If you experience problems securing the the retaining ring with the driver or wrench. If you experience problems securing the
the retaining ring with the driver or wrench. If you experience problems securing the
retaining ring, back the ring off the filter cup and tr
retaining ring, back the ring off the filter cup and tr retaining ring, back the ring off the filter cup and tr
retaining ring, back the ring off the filter cup and try again.
y again. y again.
y again.
After loading the filter(s), check each newly loaded filter position to make sure that the
retaining ring is not projecting above the top edge of the filter cup then replace the loading
port plug.
Another potential complication of loading filters into the filter cups can occur if the retaining
ring has been previously over-tightened. In this case, it is possible that the filter cup itself
will begin to unscrew from the wheel as the retaining ring is turned. If this occurs, STOP!
Filter position at optical port 0 1 2 3 4 5 6 7 8 9
Filter position at loading port 5 6 7 8 9 0 1 2 3 4