Sutter Instrument Lambda 10-3, Руководство по эксплуатации

Страница: 86 / 132

LAMBDA 10-3 OPERATION MANUAL – REV. 3.03 (20110829)
74
Table 8-1. Lambda 10-3 Parallel Interface Pin Assignments
Pin # Pin # Pin # Pin # Function Function Function Function
1 Not Connected (NC)
2 Bit 0 for Filter Position
3 Bit 1 for Filter Position
4 Bit 2 for Filter Position
5 Bit 3 for Filter Position
6 Bit 0 for Speed
7 Bit 1 for Speed
8 Bit 2 for Speed
9 Wheel Select Bit
10 NC
11 Busy Line Output
12 Error Line Output
13 NC
14 Shutter A
15 NC
16 Shutter B
17 NC
18 NC
19 NC
20 NC
21 NC
22 NC
23 NC
24 Ground
25 Ground
8.2
8.2 8.2
8.2 Input Command Structure
Input Command Structure Input Command Structure
Input Command Structure
Input Commands to the controller via the parallel port are structured in a one-byte (8-bit)
signal. These eight bits are transmitted to the Lambda 10-3 controller via the eight input
lines (Pin 2 through Pin 9) of the parallel port connector. The eight bits can be used to
convey two types of input commands.
Filter Commands: Filter Commands: Filter Commands: Filter Commands: These input commands select the desired filter position (0 – 9),
switching speed (0 – 7), and filter wheel (A or B).
Special Commands: Special Commands: Special Commands: Special Commands: These input commands are used to set the controller to the ON LINE
(Remote) mode of operation, control the shutter(s) (when installed), and make BATCH
TRANSFERS of input commands to the controller.