1. Before gas conversion, remove knob lock
by removing screw. (See Figure 19 & 20)
2. Before changing, the knob is in the NG
position (See Figure 22). For Propane/
LP GAS, push the knob and turn
counterclockwise until the knob
locks into the LP position (See Figure
23). The selection valve must be locked
in the LP position. DO NOT operate the
heater between the locked positions.
3. Remove the cap by hand from the
regulator and now the white plastic screw
is in the NG position (See Figure 24-1).
4. Remove the white plastic screw from the
cap (See Figure 24-2).
5. Turn it over (See Figure 24-3) and
reinstall it on the cap (See Figure 24-4).
Make sure the white plastic screw is
installed on the cap tightly.
6. Replace the cap on the regulator.
7. After gas conversion, make sure to replace
knob lock and the screw.
Figure 22 - NG Position
INSTALLATION
Continued
Figure 23 - LP Position
Figure 24 - Setting Regulator to Change From Natural Gas to Propane/LP Supply
16
Figure 24-1
Figure 24-2
Figure 24-3
Figure 24-4
Cap
White plastic screw
NG to LP Conversion Operation
WARNING: Only a qualified installer
or service technician can perform gas
selection and connecting to gas supply.
