INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Re-
move mounting bracket from heater carton.
Removing Shell Front Of Heater
1. Remove the four painted screws, two on
side of Shell Front.
2. Pull bottom of Shell Front forward, then out.
3. Remove any remaining packaging materials.
Attaching to Wall Anchor:
This method al-
lows you to attach mounting bracket to hollow
walls (wall areas between studs) or to solid
walls (concrete or masonry).
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall where
heater will be located. Make sure mount-
ing bracket is level.
9
Figure 6 - Removing Shell Front Of
Heater
Methods For Attaching Mounting Bracket
To Wall
Only use last hole on each end of mounting
bracket to attach bracket to wall. Attach
mounting bracket to wall in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud
:
This method pro-
vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.
INSTALLATION
Continued
Figure 5 - Mounting Bracket
WARNING: Maintain minimum
clearances shown in Figure 8. If you
can, provide greater clearances from
fl oor and joining wall.
Shell Panel
Screws
2. Mark screw locations on wall (see Figure 7).
Note: Only mark last hole on each end of
mounting bracket. Insert mounting screws
through these holes only.
3. Remove tape and mounting bracket from
wall.
Figure 7 - Mounting Bracket Clearances
A
B
C
ITEM NO. BWH10NLM BWH20NLTB BWH30NLTB
A
8"
12"
16"
B
11"
14"
14"
C
18 3/4"
19 3/4"
19 3/4"
