Supero SUPERSERVER 8046B-6RF, Руководство пользователя

Страница: 62 / 104

6-6
S
UPER
S
ERVER 8046B-6RF/8046B-TRF User's Manual
6-4 Drive Bay Installation
Hard Drives
The hard drives are mounted in drive carriers to simplify their installation and
removal from the chassis. These carriers also help promote proper airfl ow for the
drives. For this reason, even empty carriers without hard drives installed must
remain in the chassis. A total of fi ve SAS or SATA drives may be housed in the
SC748TQ-R1400BP chassis. The drive IDs are preconfi gured as 0 through 4 in
order from right to left (or from bottom to top if rackmounted).
Installing/Removing Hot-swap Hard Drives
The hard drive carriers are all easily accessible at the front of the chassis. These
drives are hot-swappable, meaning they can be removed and installed without
powering down the system.
Push the release button on the carrier located beside the drive LEDs. 1.
Swing the handle fully out and then use it to pull the drive straight out. 2.
Note: Your operating system must have RAID support to enable the hot-swap
capability of the hard drives.
Mounting a Hard Drive in a Drive Carrier
The hard drive carriers help to promote proper airfl ow for the system. For this reason,
even carriers without hard drives must remain in the server.
Insert the drive into the carrier with the printed circuit board side facing down 1.
so that the mounting holes align with those in the carrier.
Secure the drive to the carrier with four screws (see Figure 6-5). 2.
SAS/SATA Backplane
The hard drives plug into a SAS/SATA backplane on the CSE-M35P mobile rack,
which houses the hard drive bays. The drive data cables must be connected from
the serverboard to the appropriate connectors on the backplane. There are also two
power connectors on the backplane - both should be connected.