Supero SUPERSERVER 8046B-6RF, Руководство пользователя

Страница: 18 / 104

2-4
S
UPER
S
ERVER 8046B-6RF/8046B-TRF User's Manual
2-4 Installing the System into a Rack
This section provides information on installing the system into a rack unit. Rack
installation requires the use of the optional rackmount kit If the system has already
been mounted into a rack or if you are using it as a tower, you can skip ahead to
Sections 2-5 and 2-6. There are a variety of rack units on the market, which may
mean the assembly procedure will differ slightly. The following is a guideline for
installing the server into a rack with the rack rails provided in the rackmount kit.
You should also refer to the installation instructions that came with the rack unit you
are using. Note: The outer rail is adjustable from 26" to 38.25".
Removing the Chassis Cover and Feet
The SC748 chassis is shipped with the chassis cover and feet pre-installed. Both
the feet and cover must be removed for before installing the rails.
Removing the Chassis Top Cover
Locate the chassis cover lock (blue lever) at the rear of the chassis cover. 1.
Slide the chassis cover lock to the right and push chassis cover forward. 2.
Lift the chassis top cover off the chassis. 3.
Removing the Chassis Feet
Place the chassis on its side with the chassis side cover facing upward. 1.
Remove the screw holding the chassis foot in place. 2.
The foot lock is a tab located in the center of the foot that prevents the foot 3.
from sliding. Using a fl at head screwdriver, gently lift the foot lock upward
and slide the foot toward the rear of the chassis.
Repeat steps 2 and 3 with each remaining foot. 4.