Supero SUPERSERVER 6016T-MR, Руководство пользователя

Страница: 67 / 106

Chapter 6: Advanced Chassis Setup
6-5
Remove the drive from the drive tray. 3.
To add a new SATA drive, install a drive into the tray 4. with the printed circuit
board side facing down and so that the mounting holes align with those in the
tray.
Secure the drive to the tray with the four screws. 5.
Replace the top cover when fi nished. See Figure 6-3. 6.
Note: the 6016T-MR can accommodate two internal SATA hard drives, one on
each side of the fans.
!
Enterprise level hard disk drives are recommended for use in Supermicro
chassis and servers. For information on recommended HDDs, visit the
Supermicro Web site at http://www.supermicro.com/products/nfo/storage.
cfm
DVD-ROM Drive Installation
The top cover of the chassis must be opened to gain full access to the DVD-ROM
drive bay. The DVD-ROM must have a "slim" profi le to fi t into the 6016T-MR. If
you cannot remove the top cover with the system remaining in the rack, follow the
procedure below.
DVD-ROM Drive Installation
First shutdown the system and disconnect the AC power cable. 1.
Make sure the system is supported from underneath then remove the front 2.
bracket screws that secure the unit to the rack.
Carefully lift the server out of the rack. 3.
Open the cover by following the procedure described on page 6-7. 4.
Remove the screws that secure the DVD-ROM drive to the chassis and then 5.
lift the drive out of the chassis. See Figure 6-3.
Note: A red mark on a ribbon cable typically designates the location of pin 1.