Supero SUPERSERVER 6016T-MR, Руководство пользователя

Страница: 43 / 106

Chapter 5: Advanced Serverboard Setup
5-7
Installing a Passive CPU Heatsink
Screw#1
Screw#1
Screw#2
Screw#2
Install Screw#1
Notes : The serverboard comes
with a heatsink bracket pre-in-
stalled on the reverse side of the
board. Do not apply any thermal
grease to the heatsink or the CPU
die; the required amount has al-
ready been applied.
Place the heatsink on top 1.
of the CPU so that the four
mounting holes are aligned
with those on the retention
mechanism.
Install two diagonal screws 2.
(i.e. the #1 and the #2
screws) and tighten them until
just snug (do not fully tighten
the screws to avoid damaging
the CPU.)
Repeat step 2 with the #3 3.
and #4 screws. Make sure all
screws are snug.
Install Screw#2
Screw#1
Screw#3
Screw#4
Note: two different heatsinks are used in the 6016T-MR. SNK-P0037P is for CPU1
and SNK-P0041 is for CPU2. See the serverboard layout page for the locations of
CPU1 and CPU2.