Supero SUPERSERVER 5015B-T, Руководство пользователя

Страница: 22 / 102

2-8
S
UPER
S
ERVER 5015B-T User's Manual
2-5 Checking the Motherboard Setup
After you install the 5015B-T in the rack, you will need to open the unit to make sure
the motherboard is properly installed and all the connections have been made.
Accessing the inside of the System
First, release the retention screws that secure the unit to the rack. Grasp the
two handles on either side and pull the unit straight out until it locks (you will
hear a "click").
Next, depress the two buttons on the top of the chassis to release the top
cover. There is a large rectangular recess in the middle front of the top cover
to help you push the cover away from you until it stops.
You can then lift the top cover from the chassis to gain full access to the
inside of the server.
Checking the Components and Setup
You may have one processor already installed into the system board. Each
processor should have its own heatsink attached. See Chapter 5 for instruc-
tions on processor installation.
Your 5015B-T server system may have come with system memory already
installed. Make sure all DIMMs are fully seated in their slots. For details on
adding system memory, refer to Chapter 5.
If desired, you can install an add-on card to the system. See Chapter 5 for
details on installing a PCI add-on card.
Make sure all power and data cables are properly connected and not blocking
the airfl ow. Also make sure that no cables are positioned in front of the fans.
See Chapter 5 for details on cable connections.
1.
2.
3.
1.
2.
3.
4.