Supero SUPERSERVER 5015B-T, Руководство пользователя

Страница: 58 / 102

6-4
S
UPER
S
ERVER 5015B-T User's Manual
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
Serial ATA Drives: Because of their hotswap capability, you do not need to access
the inside of the chassis or power down the system to install or replace Serial ATA
drives. Proceed to the next step for instructions.
DVD-ROM/Floppy Disk Drives: For installing/removing a DVD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the 5015B-T by removing the
top cover of the chassis. Proceed to the "DVD-ROM and Floppy Drive Installation"
section later in this chapter for instructions.
Note: Only a "slim" DVD-ROM drive will fi t into the 5015B-T.
Serial ATA Drive Installation
The Serial ATA drives are mounted in drive carriers to simplify their installation
and removal from the chassis. These carriers also help promote proper airfl ow for
the Serial ATA drive bays. For this reason, even empty carriers without Serial ATA
drives installed must remain in the chassis. The drives are hot-swappable, mean-
ing they can be installed and removed without powering down the system.
Mounting a SATA Drive in a Drive Carrier
To add a new Serial ATA drive, install a drive into the carrier with the printed
circuit board side toward the carrier so that the mounting holes align with
those in the carrier.
Secure the drive to the carrier with four screws, as shown in Figure 6-3.
Installing/removing hot-swap Serial ATA drives
To remove, fi rst push the release button located beside the drive LEDs.
Swing the colored handle fully out and use it to pull the unit straight out (see
Figure 6-4).
Note: Your OS must have RAID support to enable the hot-plug capability of the
SATA drives.
1.
2.
1.
2.