Supero SuperServer 5014C-M8, Руководство пользователя

Страница: 61 / 110

Chapter 6: Advanced Chassis Setup
6-3
6-3 System Fans
Three 4-cm high-performance fans provide the cooling for the SuperServer
5014C-M8. The chassis includes air seals under the fans and at the chas-
sis cross section, which separates the drive bay area from the mother-
board area of the chassis to promote better airflow. It is highly important
that the air seal is properly installed and making a good seal in order for the
cooling air to circulate properly through the chassis.
The fans can adjust their speed according to the heat level sensed in the
system, which results in more efficient and quieter fan operation. Fan
speed is controlled by a setting in BIOS (see page 7-13).
System Fan Failure
If a fan fails, you will need to have it replaced with the same type. Contact
your vendor or Supermicro for information on replacement fans.
6-4 Drive Bay Installation/Removal
Removing the Front Bezel
If your system has a front bezel (optional) attached to the chassis, you must first
remove it to gain access to the drive bays. To remove the bezel, first unlock the
front of the chassis then press the release knob (see Figure 6-3). Carefully
remove the bezel with both hands. A filter located within the bezel can be re-
moved for replacement/cleaning. It is recommended that you keep a maintenance
log of filter cleaning/replacement, since its condition will affect the airflow through-
out the whole system.
Figure 6-3. Removing the Front Bezel
1. Unlock
2. Press release knob
3. Remove bezel assembly