Supero SuperServer 5014C-M8, Руководство пользователя

Страница: 38 / 110

5-2
S
UPER
S
ERVER 5014C-M8 User's Manual
5-2 Motherboard Installation
This section explains the first step of physically mounting the P8SC8 into
the SC813MS-300C chassis. Following the steps in the order given will
eliminate the most common problems encountered in such an installation. To
remove the motherboard, follow the procedure in reverse order.
1. Accessing the inside of the system (see Figure 2-5)
Two release buttons are located on the top cover of the chassis.
Depressing both of these buttons while pushing the cover away from
you until it stops. You can then lift the top cover from the chassis to
gain full access to the inside of the server. (If already installed in a
rack, you must first release the retention screws that secure the unit
to the rack. Then grasp the two handles on either side and pull the unit
straight out until the rails lock into place.)
2. Check compatibility of motherboard ports and I/O shield
The P8SC8 requires a chassis big enough to support a 12" x 9.5"
motherboard, such as Supermicro's SC813MS-300C 1U rackmount.
Make sure that the I/O ports on the motherboard align properly with
their respective holes in the I/O shield at the back of the chassis.
3. Mounting the motherboard onto the motherboard tray
Carefully mount the motherboard to the motherboard tray by aligning
the board holes with the raised metal standoffs that are visible in the
chassis. Insert screws into all the mounting holes on your motherboard
that line up with the standoffs and tighten until snug (if you screw
them in too tight, you might strip the threads). Metal screws provide an
electrical contact to the motherboard ground to provide a continuous
ground for the system.
Unpacking
The motherboard is shipped in antistatic packaging to avoid electrical static
discharge. When unpacking the board, make sure the person handling it is
static protected.