Supero SuperServer 5013C-i, Руководство пользователя

Страница: 22 / 118

2-4
S
UPER
S
ERVER 5013C-T/5013C-i User's Manual
2-4 Installing the 5013C-T/5013C-i into a Rack
This section provides information on installing the SuperServer 5013C-T/
5013C-i into a rack unit. If the system has already been mounted into a
rack, you can skip ahead to Sections 2-5 and 2-6. There are a variety of
rack units on the market, which may mean the assembly procedure will
differ slightly. The following is a guideline for installing the unit into a rack
with the rack rails provided with the system. You should also refer to the
installation instructions that came with the rack unit you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer
5013C-T/5013C-i. Each of these assemblies consist of two sections: an
inner fixed chassis rail that secures to the unit (A) and an outer fixed rack
rail that secures directly to the rack itself (B). A sliding rail guide sand-
wiched between the two should remain attached to the fixed rack rail (see
Figure 2-1). The A and B rails must be detached from each other to install.
To remove the fixed chassis rail (A), pull it out as far as possible - you
should hear a "click" sound as a locking tab emerges from inside the rail
assembly and locks the inner rail. Then depress the locking tab to pull the
inner rail completely out. Do this for both the left and right side rack rail
assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
Mounting Holes
A
Locking Tab
B