Supero SuperServer 5013C-i, Руководство пользователя

Страница: 13 / 118

Chapter 1: Introduction
1-3
Processors
The P4SCE supports single Intel
®
Pentium
®
4 processors of up to 3.40 GHz
with a 2 MB integrated Advanced Transfer Cache and hyper-threading tech-
nology and single Intel
®
Celeron
®
processors of up to 2.40 GHz with a
128KB integrated Advanced Transfer Cache in 478-pin microPGA sockets.
Please refer to the support section of our web site for a complete listing of
supported processors (http://www.supermicro.com/support/).
Memory
The P4SCE has four (4) 184-pin DIMM sockets that can support up to 4 GB
of ECC or non-ECC unbuffered DDR-400/333/266 SDRAM modules. Low-
profile memory modules are required for use in the 1U form factor of the
5013C-T/5013C-i. Module sizes of 256 MB, 512 MB and 1 GB may be used
to populate the DIMM slots. All memory modules must be the same size and
speed.
Serial ATA (5013C-T)
A Serial ATA controller is incorporated into the E7210 chipset to provide a
two-port Serial ATA subsystem, which is RAID 0 and RAID 1 supported.
The Serial ATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the
hot-swap capability and RAID function of the Serial ATA drives.
PCI Expansion Slots
The P4SCE has five 32-bit, 33 MHz PCI slots available. One riser card is
included with the system for use with 32-bit PCI cards.
Ethernet Ports
The P4SCE has an onboard controller that supports two Gigabit LAN ports.
Onboard Controllers/Ports
An onboard IDE controller supports one floppy drive and up to four Ultra
ATA 100 hard drives or ATAPI devices. Onboard I/O backpanel ports in-
clude one COM port, one parallel port, two USB ports, PS/2 mouse and
keyboard ports and two GLAN (NIC) ports.