Supero SuperServer 5013C-i, Руководство пользователя

Страница: 59 / 118

Chapter 6: Advanced Chassis Setup
6-3
6-3 System Fans
Two 10-cm blower fans provide the cooling for the SuperServer 5013C-T/
5013C-i. The chassis includes air seals under the blower fans and at the
chassis cross section, which separates the drive bay area from the moth-
erboard area of the chassis to promote better airflow. It is highly important
that the air seal is properly installed and making a good seal in order for the
cooling air to circulate properly through the chassis.
System Fan Failure
The blower fans run at a full 100% rpm. If a fan fails, you will need to have
it replaced with the same type. Contact your vendor or Supermicro for
information on replacement fans.
cabling out of the airflow path. The LEDs inform you of system status. See
Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
Serial ATA Drives: Because of their hotswap capability, you do not need to
access the inside of the chassis or power down the system to install or
replace Serial ATA drives. Proceed to the next step for instructions.
CD-ROM/Floppy Disk Drives: For installing/removing a CD-ROM or floppy disk
drive, you will need to gain access to the inside of the 5013C-T/5013C-i by
removing the top cover of the chassis. Proceed to the "CD-ROM and Floppy
Drive Installation" section later in this chapter for instructions.
Note: Only a "slim" CD-ROM drive will fit into the 5013C-T/5013C-i.