Supero Supero SUPERSERVER 5025B-4, Руководство пользователя

Страница: 63 / 138

Chapter 6: Advanced Chassis Setup
6-7
Installing Components in the 5.25" Drive Bays
The SC822S-400LP/SC822TQ-400LP chassis has two 5.25" drive bays. Compo-
nents such as an extra fl oppy drive or CD-ROM drives can be installed into these
5.25" drive bays.
Removing the Empty Drive Bay
First power down the system.
Remove the top/left chassis cover to access the drive components.
With the cover off, remove the screws that secure the drive carrier to the
chassis (one side only) then push the entire empty drive carrier out from the
back.
Adding a Slim DVD/CD-ROM Drive
5025B-4
Remove the guide plates (one on each side) from the empty drive carrier
and screw them into both sides of the DVD/CD-ROM drive using the holes
provided.
Slide the DVD/CD-ROM into the bay and secure it to the chassis with the
drive carrier screws you fi rst removed.
Attach the power and data cables to the drive.
Replace the top/left chassis cover and restore power to the system.
5025B-T
Because the motherboard does not have an IDE port, adding a DVD/CD-ROM drive
to the 5025B-T will occupy one of the SATA ports on the backplane.
Add the IDE to SATA adapter (CDM-PSATA) to any one of the SATA ports on
the backplane to accommodate the DVD/CD-ROM drive.
Follow the procedure above to install the DVD/CD-ROM drive into the same
SATA drive bay that you added the adapter to.
Attach the power and data cables to the drive.
Replace the top/left chassis cover and restore power to the system.
1.
2.
3.
1.
2.
3.
4.
1.
2.
3.
4.