Supero Supero SUPERSERVER 5025B-4, Руководство пользователя

Страница: 52 / 138

5-20
S
UPER
S
ERVER 5025B-4/5025B-T User's Manual
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
3rd Power Fail Detect
The system can notify you in the event
of a power supply failure. This feature
is available when three power supply
units are installed in the chassis with
one acting as a backup. If you only have
one or two power supply units installed,
you should disable this detection feature
(the default setting) with J3P to prevent
false alarms.
3rd Power Fail Detect
Jumper Settings (J3P)
Jumper Setting Defi nition
Closed Enabled
Open Disabled
LAN1/2 Enable/Disable
Change the setting of jumper JPL1
and JPL2 to enable or disable the
LAN1 and LAN2 Ethernets ports, re-
spectively. See the table on the right
for jumper settings. The default setting
is enabled.
LAN1/2 Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SMBus to PCI-X/PCI-E Slots
Jumper Settings (JI 2 C1/JI 2 C2)
Jumper Setting Defi nition
JI
2
C1: Closed JI
2
C2:Closed Enabled
JI
2
C1: Open JI
2
C2: Open Disabled
SMBus to PCI-X/PCI-Exp. Slots
Jumpers JI
2
C1 and JI
2
C2 allow you to
connect the System Management Bus
(I
2
C) to the PCI-X/PCI-E slots. The
default setting is Open (Disabled.) Both
jumpers must be set to the same setting
See the table on the right for jumper
settings.