Supero Supero SUPERSERVER 5025B-4, Руководство пользователя

Страница: 18 / 138

2-4
S
UPER
S
ERVER 5025B-4/5025B-T Manual
2-4 Installing the System into a Rack
This section provides information on installing the SuperServer 5025B-4/5025B-T
into a rack unit. If the 5025B-4/5025B-T has already been mounted into a rack, you
can skip ahead to Sections 2-5 and 2-6.
There are a variety of rack units on the market, which may mean the assembly
procedure will differ slightly. The following is a guideline for installing the 5025B-
4/5025B-T into a rack with the rack rails provided. You should also refer to the
installation instructions that came with the rack unit you are using.
Identifying the Sections of the Rack Rails
You should have received two rack rail assemblies with the SuperServer 5025B-
4/5025B-T. Each of these assemblies consist of three sections: an inner fi xed
chassis rail that secures to the 5025B-4/5025B-T (A) and an outer fi xed rack rail
that secures directly to the rack itself (B). A sliding rail guide sandwiched between
the two should remain attached to the fi xed rack rail (see Figure 2-1). The A and B
rails must be detached from each other to install.
To remove the fi xed chassis rail (A), pull it out as far as possible - you should hear
a "click" sound as a locking tab emerges from inside the rail assembly and locks
the inner rail. Then depress the locking tab to pull the inner rail completely out. Do
this for both the left and right side rack rail assemblies.
Figure 2-1. Identifying the Sections of the Rack Rails
A
B