2-8
SUPER i2DML-8G2/i2DML-iG2 User's Manual
F. Installing the Heatsink on the CPU(*for CPU w/o Heatsink
only)
(
*Warning
:
Do not apply any thermal grease to the heatsink-the required
amount of thermal grease has already been applied.)
1. Place the heatsink (P/N SKT-0046) on top of the CPU so that the four
mounting holes are aligned with those on the retention mechanism as
shown in Figure 1 below.
2. Screw in two diagonal screws (ie the #1 and #2 screws) until just
snug (do not fully tighten), then do the same with the remaining diagonal
screws as shown in Figure 2 and Figure 3.
1) Locate the four mounting holes on
the heatsink retention module.
Figure 1
Figure 2
Figure 3
(
*Note:
To maximizing the cooling effect of the i2DML-8G2/iG2, we
strongly recommend that Supermicro's proprietary heatsinks (SNK-046)
be used with the Itanium 2 CPUs.)
