Supero 5037A-I, Руководство пользователя

Страница: 41 / 102

Chapter 5: Advanced Serverboard Setup
5-19
Trusted Platform Module Header
Pin Definitions
Pin # Definition Pin # Definition
1 LCLK 2 GND
3 LFRAME 4 No Pin
5 LRESET 6 VCC5
7 LAD3 8 LAD2
9 VCC3 10 LAD1
11 LAD0 12 GND
13 RSV0 14 RSV1
15 SB3V 16 SERIRQ
17 GND 18 CLKRUN
19 LPCPD 20 RSV2
TPM Header (JTPM1)
This header is used to connect a Trusted
Platform Module (TPM), which is available
from a third-party vendor. A TPM is a se-
curity device that supports encryption and
authentication in hard drives. It enables the
motherboard to deny access if the TPM as-
sociated with the hard drive is not installed
in the system. See the table on the right for
pin definitions.
Power Supply I
2
C ( JPI
2
C)
The Power Supply I
2
C Connector, located
at JPI
2
C, monitors the status of the power
supply, fan and system temperature. See
the table on the right for pin definitions.
PWR Supply I
2
C
Pin Definitions
Pin# Definition
1 Clock
2 Data
3 PWR Fail
4 Ground
5 3.3V
PCI Slot SMB Enable
Jumper Settings
Jumper Setting Definition
Short (Default) Enabled
Open Disabled
PCI Slot SMB Enable (J I
2
C1/JI
2
C2)
Use Jumpers I
2
C1/I
2
C2 to enable PCI
SMB (System Management Bus) support
to improve system management for the
PCI slots. See the table on the right for
jumper settings.
A. Internal Buzzer
B. Wake On LAN
Legacy Wake-On-LAN Header (JSTBY)
The onboard LANs (LAN1 and LAN2)
do not need WOL header to support its
Wake-On-LAN function. We preserved
the legacy WOL header to provide con-
venience for some embedded customers
who need internal power source from the
board. See the table on the right for pin
definitions.
Wake-On-LAN
Pin Definitions
Pin# Definition
1 +5V Standby
2 Ground
3 Wake-up